Categories
Contact Us
Question about this product?

Customer Service Phone:

877-696-4455

First Name:

Email Address:

Phone Number:

Message:

Meguiars Mirror Glaze No.8 Wax 11oz

Meguiars Mirror Glaze No.8 Wax 11oz
Meguiars Mirror Glaze No.8 Wax 11oz
Product Code:  MEG-108
Availability:In Stock
Price:$16.00
Price in reward points: 52
Qty:  
   - OR -   
(Note: Meguiars sold the production rights for this product to Stoner and it is now called Miracle Gloss No. 8)
 
This is a super high quality wax designed for maximum mold release with epoxy or polyesters.  We have used this wax for years on all of our parts that we manufacture at ambient temperature. It leaves the shop smelling great but more importantly, it works great!
 
It works by creating a barrier-film that provides multiple releases with ultra high gloss finished parts on new and seasoned molds. 
The industry's first and most widely used mold release wax - Recognized worldwide as the industry standard for paste mold release waxes - Wax of choice when maximum release power is required - Withstands exothermic temperatures up to 250° F (121º C) 
 
Benefits: - Specially formulated to provide the maximum number of releases - Especially useful on tooling, new molds, and production use 
Tools Needed: Meguiar's Foam Applicator (W-0004) or 100% cotton terry cloth towel Mold Prep: New mold or plug must be fully cured before using the Meguiar's Maximum Mold Release Wax (M-08). 
Safety Tip: Always wear appropriate eye and skin protection. 
Safety Data: Material Safety Data Sheets are available for all Meguiar's products and should be consulted prior to use of the product. 
Professional Tips: For the highest quality parts, precede Meguiar's Maximum Mold Release Wax (M-08) with Meguiar's Velocity line of cleaner, compounds, and polishes. 
DIRECTIONS: Meguiar's Maximum Mold Release Wax (M-08) should be applied at ambient room temperatures above 50º F (10º C). New and Seasoned Molds: 1. Apply by hand five (5) to eight (8) coats of Meguiar's Maximum Mold Release Wax (M-08). o Apply a thin coat of wax, wait for approximately 5 to 10 minutes for the wax to haze up. o Wipe off the haze using a 100% cotton terry cloth towel. o Wait for an additional 20 to 30 minutes for the wax to fully cure then apply next coat. 2. Once all five (5) to eight (8) coats have been applied, the mold is ready for production. 3. For the first five (5) pulls add one (1) additional coat between each pull. 4. After the fifth pull, run mold until release becomes slight snug then apply one (1) additional coat of wax.

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating:Bad           Good

Enter the code in the box below:



Tags:
Specials
illstreet Composites, LLC